ID: 963
Kenwood KAC-649S 4x 30W versterker
€6,50
Geen aanbiedingen geplaatst
Omschrijving
Kenwood KAC-649S auto versterker. Past perfect onder de stoel van een Citoën C1, Toyota Aygo, Peugeot 107 of in de reparatieset-uitsparing van een Mini Cooper. Kan gebrugd worden naar stereo en subwoofer versterker.
Features
Protection circuitry:
Controls:
Inputs and Outputs
Right Side of the Amplifier
Left Side of the Amplifier
Additional Specifications
Specifications:
Features
Protection circuitry:
- Speaker output contacts ground
- Speaker wire short
- Unit malfunctions and DC is sent to speaker output
- Thermal: when internal temp is high
- Loss of ground of head unit or amp
Controls:
- Filter control switches: one for A, one for B; each one can be set for high pass (150Hz), OFF, or low pass (80Hz)
- Operation control switches: one for A, one for B; each one can be set for stereo or mono (L channel)
- Input selector switch: you may select A/B position when using a source unit with dual RCA outputs or A position with amplifies any signal input to the "A" by both A and B (so an RCA "Y" adapter is not needed)
- Input sensitivity knobs (variable from 0.2 to 5V): one for A and one for B
Inputs and Outputs
Right Side of the Amplifier
- GND: philips head screw for RCA signal ground
- Speaker-level input: multi-pin input for use with included speaker level input harness
- "A" and "B" line-in jacks: two pairs of gold plated RCA inputs
- Line out jacks: gold plated RCA outputs that provide a summed signal from the "A" and "B" sets of line inputs
Left Side of the Amplifier
- Fuse: 25 amp fuse
- BATT (power): gold plated screw terminal (0.55" wide)
- GND (ground): gold plated screw terminal (0.55" wide)
- P.CON (remote turn-on): gold plated screw terminal (0.335" wide)
- Speaker outputs: gold plated screw terminals (0.335" wide) for front and rear, left and right loudspeakers (bridged = Left+ and Right-)
Additional Specifications
Specifications:
- Rated power output at 2 ohms: 30 watts x 4 (1 kHz, 0.8% THD)
- Max power output at 4 ohms: 60 watts x 4
- Max power output at 4 ohms, bridged: 160 watts X 2
- Input impedance: 10k ohms
- Operating voltage: 14.4 V (11-16V allowable)
- Current consumption (1 kHz, 10% THD): 18 amps